installing deck boards

Installation instructions for Treated lumber decking - YouTube 6 Jan 2009 byronsimon, You're right, pressure treated lumber will shrink sometime in just a month or so. That is why the TC-1 and TC-2 will allow you to install the boards tight together. Usually the boards will shrink around 1/4" and they may expand and contract naturally thru the seasons. The fastener has a span from point to point of 1.25" so it can handle the shrinking board. Also, the TC-1 and TC-2 have been on the market for close to 10 years and has proven it self to be a 

Decking Installation: how to place, space, & fasten deck boards How to lay out, place, & secure decking: the deck flooring. We describe how to lay out and fasten deck boards to the deck floor joist structure and how to decide on the appropriate deck board gap. Choices of deck board fastener types and methods include nails, screws, clips, and a wide variety of hidden deck board fastener systems that we describe here as well. This article series describes construction details for decks and porches, including deck structures, floors, and othe 

Installing New Deck Boards Over a Solid, Existing Frame - Extreme 26 Sep 2016 By Larry Walton. I had been keeping this deck alive for several years with an occasional replacement board, some sanding,a little deck stain. I even trimmed the ends of a section of the cantilevered deck boards. But now the time had arrived to build a new deck. I started pulling off deck boards hoping to find a solid structure underneath. Several observations had raised these hopes. During earlier repairs I had noted that the deck framing was pressure-treated 4×6, that 

How to Install Wood Deck Boards Today's Homeowner Building a wood deck makes a great DIY project for your home. Here are some tips when laying the deck boards. When using pressure treated wood that's still saturated with preservative, install the boards without a gap between them. As the wood dries, it will shrink, leaving a small gap between each board. Orient the deck boards so the growth rings in the end grain have the arc facing up. When nailing into the end of deck boards, turn the nail over and tap the point with a hammer to